In this tutorial, we will learn how to refill the e-liquid tank of your Joyetech Penguin electronic cigarette.
Hold the Joyetech Penguin in the palm of your hand:
You're going to remove the entire top section where the mouthpiece is located. It comes off quite easily so you can pop it off using just your thumb or you can use two hands to pull it apart if you'd prefer.
You'll see when you pull this piece off that it features a clear window that lets you check to see how much e-liquid is remaining in the tank. There's also a writable surface where you can mark down the details of the e-liquid you have in your tank if you'd like.
Turn the mouthpiece upside down to see the white stopper on the bottom.
This stopper is quite easy to pull out, you just need to find the small ridge at one end and lift:
You'll see when you pull out the white stopper that it's actually you coil. This is the part that you'll replace when you're atomizer is getting gunky, worn out or starting to produce diminished or unpleasant flavor (such as a burnt or singed taste or smell).
Now turn your attention to the two holes inside the main mouthpiece itself. One hole is where you refill the e-liquid tank. The other hole is where air goes up and out to the mouthpiece. It's easy to tell which is which because the hole to the mouthpiece is aligned directly above it. If you put e-liquid in the wrong hole, it will just drip through and out of the mouthpiece onto your hands.
Using a dropper, squeeze bottle or syringe, drop e-liquid into the hole to refill the tank. We're using Kai's Virgin Vapor's Razzmatazz. : )
When the tank is full (you can tell by checking the eliquid level in the see through window on the side of the tank), snap the white plastic coil back in place.
Then turn the entire mouthpiece unit back over and snap it back into place on the body of the Joyetech Penguin:
Once your Joyetech Penguin is reassembled, you're all done and ready to vape!